First, technical characteristics and performance

HTGZ-YD-series mobile mold dryer is developed by our company according to the user's process requirements and comprehensive foreign advanced technology. The equipment is mainly used for mold and sand core baking mold, dehumidification and surface drying, maintaining the hot state of the mold and dehumidifying and dehumidifying. It is especially suitable for the large-scale and medium-sized molds to be re-baked and dried in the whole place after the boxing. It is used as a large and medium-sized mold to dehumidify in the process of packing after the sub-box split core is baked in the oven. A process-critical equipment that is exposed to moisture, cold iron, and cannot meet the requirements of the casting process. The device has good thermal effects, low noise and fast heat transfer. It is an effective solution to optimize the casting process and ensure the quality of castings.

Various energy sources such as electric heating, natural gas, and fuel oil can be used as thermal energy.

Most users currently choose electric heating mobile mold dryers. The electric heating tube used by our company has fins, which has fast heating and uniform heat transfer, and the material is stainless steel. During the operation control, you can choose manual control or automatic control. The temperature controller is automatically controlled by PID, and the heating process is step-by-step from low temperature to high temperature, and the proper temperature in the cavity is controlled according to the process requirements. More than four hot air interfaces. One end of the stainless steel air supply hose is fixed to the dryer interface, and the other end sends hot air to the mold cavity. It can be connected to the mold air inlet by any standard joint connection. The metal hose has a double-layer structure, the inner tube is a stainless steel corrugated tube, the middle is sandwiched with a heat insulating material, and the outer layer is a stainless steel wire protective layer to prevent the worker from being burnt during the operation and the hot air tube being deformed under pressure.

Scope of application: The surface of all kinds of molds is heated and the outlet temperature is adjustable from 100 °C to 350 °C.